The die has long since been cast and the Stoner-based carbine is now the patrol rifle of choice for U.S. law enforcement. That being the case, we need to get our troops out training with these guns if we expect them to have the confidence and ability to use them in a crisis.
While the .223 Remington cartridge, with the appropriate load, is vastly superior as a fight stopper when compared to a handgun, it also offers some challenges in training. First of all, training ammo for the .223 costs about twice as much as comparable training ammo for a sidearm. Also, we must take into account that many (not all, save your letters) indoor ranges and subsequently the target frames, carries, backstop etc. are set up for pistol calibers, not centerfire rifle.
Also, minimum safe distance when engaging reactive steel targets with handguns versus rifles are very different. Rifle grade steel is more expensive, heavier, and generally harder to come by than comparable pistol grade steel targets.
One solution is to purchase a couple, or a few, 9mm carbines that mimic the standard AR platform with the exception of the magazines. In this arena, CMMG, Inc. of Fayette, Missouri has you covered. During this review we’ll examine both 9x91mm and .223 Remington carbines from CMMG side by side.
Presented for your consideration are M4 style carbines with sixteen inch barrels. One model chambers the 5.56mm/.223 Remington round and the other the 9x19mm round. Both have flat-top receivers, 4-way rail aluminum forearms, and retractable stocks.
The free-floating 5.56mm barrel has 1 in 7 right hand twist rifling. The 9mm version used 1 in 10 rifling. Both barrels were capped with a NATO-style birdcage flash suppressor. Also, each carbine used a Picatinny rail gas-block.
As for operation, the 5.56mm model was CMMG’s new gas-piston carbine and the 9mm version used a straight blowback, recoil operated mechanism. All external controls for both carbines were standard AR configuration including the bolt catch, magazine release button, manual safety lever and trigger.
The lower receivers on these guns varied in that the 5.56mm model was a standard AR configuration and was fed by all AR style magazines. The 9mm lower was a dedicated receiver, not a plugged or modified AR-type. Metalform 32 round stick magazines fed the 9mm carbine.
.223 Remington Ammo
Hornady has been offering their TAP (Tactical Application Police) defensive line for some time now and it has seen success in real world encounters. Featured herein would be their 60 grain TAP load chambered in .223 Remington. I would also use the Winchester USA white box 55grain FMJ load.
Benching the rifle, once I had the EOTech optic properly zeroed I put some test patterns down range. The resulting groups were predictably tight. A tight 1.17 inch three shot cluster at fifty yards proved the carbine and ammo combination could be counted on.
From the 9mm pistol ammunition side of house I chose the new Winchester PDX1 brand and the USA white box 115grain FMJ. The PDX load in question was a 147 grain bonded JHP. If this bullet looks familiar it is because the copper-colored projectile is the heart of Winchester’s Ranger L.E. ammunition line. Again, from fifty yards I fired several test groups on paper. The best group was right at 1.25 inches.
Yes, you absolutely want to train people with the gear they are carrying. However, there is no getting around the fact that centerfire rifle training requires more specialized or dedicated facilities and targets.
I’ve trained all over the United States and finding and indoor range where centerfire rifles are permitted is difficult. Many training facilities will deal with the rifle situation by shooting only frangible projectile ammunition. That works but again, the cost of frangible rifle ammo mean high cost, therefore fewer rounds put down range.